 |
Air Powered Rocket Launcher and Rocket Rally 
|
Standings: Rocket Rally 1
| Grd | Builder | Range | Class |
|---|---|---|---|
| 11 | Jeff King | 89.5 | MI |
| 11 | Doug Swingley | 89.5 | MI |
| 10 | Paul Gebhardt | 85.5 | DW |
| 12 | DeeDee Jonrowe | 84.5 | MI |
| 12 | John Baker | 84.1 | MI |
| 11 | Bjornar Andersen | 75.0 | HL |
| 11 | Ed Iten | 68.3 | MI |
| 10 | Jeff King | 89.5 | MI |
| 11 | Jeff King | 89.5 | MI |
| 11 | Jeff King | 89.5 | MI |
| 11 | Jeff King | 89.5 | MI |
| 11 | Jeff King | 89.5 | MI |
| 11 | Doug Swingley | 89.5 | MI |
| 10 | Paul Gebhardt | 85.5 | DI |
| 12 | DeeDee Jonrowe | 84.5 | -- |
| 12 | John Baker | 84.1 | MI |
| 11 | Bjornar Andersen | 75.0 | HL |
| 11 | Ed Iten | 68.3 | MI |
| 10 | Jeff King | 89.5 | MI |
| 11 | Jeff King | 89.5 | MI |
| 11 | Jeff King | 89.5 | MI |
| 11 | Jeff King | 89.5 | MI |
Standings provided by Digital Incarnations © 2005 AmokScience.com
 Rocket Rally |
RECORDS |
2005 results |
2006 results |
Science Club results |
 |
| MAIN |
| About |
| Make Your Own |
| Blueprints |
| Copyright |
| Provisions of Science |
 |
 |
| BUY ONLINE |
| Full Rocket Launcher |
| Unassembled kit |
| Accessories |
| Parts |
| Mail-in Order Form |
 |
 |
| LESSON PLANS |
| Rocket Building Lab |
| Trig prep lab |
| Kinematics Unit |
| Writing Rubric |
 |
Rocket Launcher Construction
Parts List| Quantity | Part | Cost per piece |
|---|---|---|
| 1 | 5 section of 2 PVC pipe (cut into 15 sections) three 15 sections are needed for construction of one launcher | |
| 1 | 2 PVC Test Tee | |
| 1 | 2 PVC male adapter | |
| 1 | 2 PVC Ball valve | |
| 3 | 2 x ½ flush bushing | |
| 2 | ½ metal bike valves | |
| 1 | ½ 90o elbow (adapts to female type threads) | |
| 1 | Teflon tape | |
| 1 | PVC primer | |
| 1 | PVC glue |
- Notes:
- Be neat with glue. Use enough but dont over glue. Use special
care when gluing valve in place.
- Dont glue threaded parts
- After applying glue, push and hold pieces together for 15 seconds to ensure they are secure. Make sure pvc overlaps at least an inch at all joints.
- Assembly instructions:
- Cut the 2 pipe to ~15 lengths
- Remove cutting residue with sandpaper or brush
- Dry Fit entire assembly
- Prime and glue each piece following instructions on glue
- Apply Teflon tape to threads and tighten firmly as possible by hand
